B22-B36 Biodiscs

BIOLOGICAL TREATMENT > B22-B36 Biodiscs

INTRODUCTION:

Biodisc is an aerobic biological treatment system for biodegradable waste that does not require the control of m.l.s.s. The bacterial population regulates itself according to the flow and characteristics of the waste, and the sludge extracted from the secondary decanter in a waste product.

Its use in small installations guarantees a constant quality of the effluent, which is difficult to obtain through active sludge because it does not require sludge control. In addition, energy consumption is much lower.

GENERAL DESCRIPTION:

FILTRAMAS,S.A. presents a wide range of biodiscs, covering up to 10,000 m2 of contact area with the B-36 series of biodiscs.

The use of biodiscs has the following ADVANTAGES:

  • Low energy consumption
  • No mixing liquor control required
  • Small dimensions and quiet operation

Biodisc B36

  • Biological purification with low energy consumption and easy maintenance with fixed support that does not require control of the blending liquor.

  • Ideal for WWTPs with 500-5,000 inhabitants and for installations with load fluctuations

  • Robust and highly experienced teams

  • Compact installations with silent operation and reduced dimensions with minimum environmental impact and absence of unpleasant odours.

Biodisc B22

The B22 biodisc has been designed and produced to offer better quality and durability than the ROTOSPIR series. It offers the knowledge and experience accumulated over fifteen years in the B36 series, a very robust mechanics and thermoformed discs in large parts.

The equipment essentially consists of the following components:

  • Geared motor unit: Direct drive is used as standard, but can also be used as a conveyor chain drive.

  • Drive shaft, made of SHEDULE -ST52 tube, with welded disc support structure. Finished by sandblasting SA 2 1/2 and 300 microns of epoxy tar.

  • Rolling bearings: The spherical rollers are widely dimensioned, calculated for a life of 100,000 hours under conditions of adequate lubrication.

  • Biomass carriers: They are made up of high-density polyethylene discs, 1.5 mm thick, with a crossflow type curl to increase the contact surface. The discs are made in two halves, with a diameter of 2,160 mm, and are crimped together by means of four steel tubes, minimum quality ST52. (Optional AISI316L). The resulting cylinder is keyed on the shaft by means of screws and held by running shoes that prevent friction against the central tube.

  • Protection covers: Constructed in GRP with white Gel Coat finish.

APPLICATIONS:

  • Small and medium sized populations
  • BOD5 elimination
  • Nitrification
  • Denitrification.

GENERAL DIMENSIONS:

BIODISCO-B36

BIODISCO-B22

CLIENTE / CUSTOMER

CANT./QTY

PROYECTO / PROJECT

ACCIONA AGUA

2

EDAR DE NAVALENO (SORIA)
ACCIONA AGUA

1

EDAR DE HONTORIA DEL PINAR (SORIA)
ARPO EMPRESA CONSTR.

1

EDAR Algar
ATECMA

1

EDAR Cortes Arenoso
ATM

2

EDAR TARAMUNDI
ATM

2

EDAR CALAVERO - ILLA (ASTURIAS)
ATM

1

EDAR EL MERUJAL (ASTURIAS)
ATM

1

EDAR LAS QUINTANAS (ASTURIAS)
ATM

1

EDAR LA BÁRGANA (ASTURIAS)
BEFESA

2

EDAR Puente Esuri /Ayamonte
CIVICONS

1

CANET LO ROIG
CONACON

1

EDAR Alozaina / Málaga
DINOTEC

2

EDAR ZUHEROS
DINOTEC

1

COLECTORES Y EDAR DE COMARES (MALAGA)
DTD

4

EDAR CASTELLAR DE LA FRONTERA Y ALMORAIMA
DYTRAS

2

EDAR en Jaen
DYTRAS

3

Jerez de la Frontera
DYTRAS

2

EDARs El Torno y Torrecera
DYTRAS

1

EDAR GAUCIN
DYTRAS

2

EDAR CASABERMEJA
DYTRAS

1

EDAR EL BURGO (MALAGA)
DYTRAS

2

EDAR ARDALES
DYTRAS

4

EDAR VILLANUEVA DEL ROSARIO (MALAGA)
DYTRAS

2

AGRUPACION VERTIDOS Y EDAR CARCABUEY
ECOLOGIA CANARIA STA LUCIA

1

EDAR Majadaciega
HERMANOS PISTON

2

Colectores y EDAR de Almogia
HIMEXSA

5

Pedro Muñoz
INFILCO ESPAÑOLA, S.A.

6

Venta de Baños
INFILCO ESPAÑOLA, S.A.

2

El Romeral y Tembleque/Toledo
LUBASA

1

Villafames
M. JOCA

2

Cardeña
PRIDESA

2

Almodovar del Campo
RENOS

1

Sierra de Engarceran
SEFRI INGENIEROS

1

EDAR Almuradiel
SOCAMEX

2

EDAR San Leonardo de Yagüe
SOCAMEX

2

EDAR LANGA DE DUERO (SORIA)
TECNOBACTER

1

EDAR Alfarnate
TRITIO

2

Pryca
TRITIO

1

Mafre
TRITIO

3

Piedrabuena
TRITIO

3

Calzada de Calatrava
TRITIO

1

Vilar de Canes
TRITIO

1

EDAR La Llosa
TRITIO

1

EDAR C.P. JAEN II
TRITIO

1

Ayto. de Costur
TRITIO

1

INCASUR
TRITIO

1

EDAR Totalán
TRITIO

1

EL BURGO
TRITIO

1

EDAR Lucientes / Castellón
TRITIO

1

EDAR La Mata de Morella
TRITIO

1

EDAR Pina de Montalgrao
TRITIO

1

EDAR´S CASTELLON: EDAR PUEBLA DE ARENOSO
TRITIO

1

CP ALBACETE
UTE ARIJA (Corsán-Corviam/Himexsa)

1

EDAR ARIJA
UTE BEGAR-COPASA

3

EDAR Dueñas
UTE BEGAR-DEPUMASTER

5

EDAR Rio Lobos
UTE MONFRAGÜE

3

EDAR Monfragüe

In the biological treatment of wastewater, a series of processes are generated based on the cultivation of bacterial microorganisms for the elimination of organic matter, nitrogen and phosphorus. It is one of the most common treatments for its simplicity and low cost.

FILTRAMAS, S.A. has a wide variety of equipment for bacterial culture applied to the treatment of urban and industrial wastewater.

Band screens are those equipments, installed in a channel or , which has a series of filtering surfaces in continuous movement. Its mission is to extract the suspended solids of a certain size that accompany the effluent. There are several types of band screens, depending on the characteristics of the effluent and the installation:

The objective of this equipment is to protect the WWTP or pumping well from the possible arrival of large objects capable of causing obstructions in the different units of the installation. This operation consists of passing the waste water through a screen that separates and evacuates the bulky materials dragged along. They will retain large-sized solids such as branches, leaves, paper, tree roots, plastics, wipes, rags, etc., preventing damage and blockages to pumps, valves, pipes and other elements present in subsequent treatment processes of the purification plant.

These devices allow to continue filtering while performing self-cleaning, being especially suitable for those applications where continuous filtering is an important parameter of the process. Filtramas recommends the installation of its FB or FW in-line filters according to the flow and filtration needs.

Filter sieves offer high performance in the solid-liquid separation process. Our range of equipment responds to the different possible needs for each case.

FILTRAMAS, S.A. has a wide range of solutions for the transport and compacting of the waste extracted by its machines, in a clean and discreet. The conveying and compacting systems can be with screws with final draining zone or hydraulic presses.

The conveyor-compactor screws supplied by FILTRAMAS, S.A., coupled together with its equipment, allow us to obtain a totally clean and fair-faced installation. The screw loading openings are designed for coupling to the discharge opening of the extraction equipment (bars movable grilles or screens), and the intermediate spaces are covered by a fairing.

In any water treatment or purification plant, there is a continuous need to isolate or regulate the flow of water in the channels and manholes or holes in walls (wall gates). This function is carried out by means of the placement of gates and cofferdams.

The result of our experience is the establishment of a standardization that determines a satisfactory result with a simple construction. For this reason, Filtramas has been developing the manufacture of penstocks and flashboards.

Filtramas manufactures channel hatches, wall hatches and cofferdams for different applications and uses.

The accumulation of solid waste in water treatment requires effective mechanized solutions for its extraction. FILTRAMAS, S.A. has a wide variety of equipment for the dragging of solid waste.

In the biological treatment of wastewater, a series of processes are generated based on the cultivation of bacterial microorganisms for the elimination of organic matter, nitrogen and phosphorus. It is one of the most common treatments for its simplicity and low cost.

FILTRAMAS, S.A. has a wide variety of equipment for bacterial culture applied to the treatment of urban and industrial wastewater.

The dewatering of sludge is an essential process in the management of solid waste generated in water treatment. FILTRAMAS, S.A. offers different mechanized solutions to the problem according to the different possible needs.

FILTRAMAS S.A. has a wide variety of solutions for all kinds of problems associated with the treatment and cleaning of water, mud and sand. We develop our specialisation on the basis of the experience accumulated by our professionals, constant effort and close collaboration with our clients. FILTRAMAS S.A. perfects new products, looking for economic and effective solutions. Any problem that arises in the handling of fluids is carefully analyzed in order to find an economically balanced solution.